We were asked by a customer in Hampshire to stitch-drill a 3m diameter circle in the floor of their underground house so they could install a sunken BBQ. We used our Hilti DD350 to carry this out, with 94No 127mm holes drilled to a depth of 400mm through brick and concrete. We then used out […]
Stitch Drilling in Hampshire Read More »
This contract consisted of wire sawing this anchor block into 3No pieces for removal by crane using our Hilti Group WS15. We then had to core drill a hole in the center with our Hilti Group DD350 and burst the sections in two using our Darda C9 Hydraulic Splitter. This reduced the weight down to the safe working load
Wire Sawing – Holmsley Bridge Read More »
Weymouth Sea Wall Track Saw This contract was carried out for a client down in Weymouth. We had to saw cut an old jetty using our Hilti Group TS20 and Tyrolit floor saw. The slab consisted of a 400mm deep reinforced slab that was sat on a hardwood frame and a number of piles that were driven
Weymouth Sea Wall – Track Sawing Read More »
Wire Sawing Beams at Bracknell – These photos show the progress we have made at Bracknell and also demonstrates the current wire sawing our operatives have been doing with the Hilti Group WS15 wire saw.
Bracknell – Wire Sawing Beams Read More »
This contract is for a client in Bracknell working alongside Specialist Cutting Services Ltd. They needed the stair core removed as quick as possible without using equipment that would cause vibration due to there being an underground car parks adjacent to the site. As you can see, we’ve core drilled several 150mm holes using our
Bracknell – Core Drilling and Track Sawing Read More »
On the other side of the project we had another parapet to cut which was exactly the same as the previous one. We had to remove the 9 m x 450 x 1m (including concrete slope behind parapet).
Cheltenham – Wire saw and track saw of old Parapet Read More »
Our client needed a slot drilled and cut to install a rainwater gully for the new road widening project. Using the Hilti Great Britain dd 350, we drilled the top of the slot and down the sides enough to not have to over cut. Then using the Hilti Great Britain ts 20 we cut the 500mm slab.
Cheltenham – Drill and cut out concrete slab for gully Read More »
We continued to work with Knights Brown on the south side of the project cutting down the old retaining wall for the road widening. We cut 17m horizontally along the bottom then vertically into 2m sections for removal.
Cheltenham – Track Sawing old retaining wall for a road widening Read More »
Last week we were working alongside Knights Brown where we revisited Cheltenham to cut another concrete upstand but this time on the south side of the road. We had to cut the beam as low to the ground as possible, now we will cut into 2m sections for removal.
Cheltenham – Track Sawing old concrete upstand Read More »
We have been working at the Savoy Hotel Bournemouth drilling holes for new air handling systems and holes for the plumbers!
Savoy Hotel Bournemouth – Drilling internal and external walls for services Read More »